• Measuring wheels

    Measuring wheels in combination with rotary encoder allows to measure direct linear motion. Diameter (Circumference) and tread depending on application. In order to prevent the result being distorted when the shaft encoder is driven by a measuring wheel make sure that the slip is as small as possible. When selecting the tread (surface), take into account the structure, stretchability, thickness, and resistance to being carried along of the material being measured. The slip is also affected by the width of the measuring wheel, the contact pressure, the tension in the material being measured, and the arc of contact. The arc of contact should be as large as possible. The wheel bodies are made of cast aluminium or plastic (as marked). The position of the measuring wheel should be chosen so that the direction of movement of the material is away from the shaft encoder’s bearing point.

    Diameter, mm:
    5,73 … 15,92
    Circumference, mm:
    182,88 … 500
    Bore ø, mm:
    4 … 12
    Aluminium / Plastic
    Width of surface, mm:
    4 … 25
    Tread 1:
    with rim and fine crosshatched knurl Material: aluminium
    Tread 2A:
    soft specially clinging rubber surface (red)
    Tread 2B:
    low-wear rubber surface with good grip (white)
    Tread 3:
    vulcanized rubber surface with parallel knurl
    Tread 4:
    aluminium with parallel knurl
    Tread 5:
    with rim, aluminium with parallel knurl
    Tread 6:
    plastic surface